Elmo ST-600D - Projection Setup and Operation; Preparing For Projection

PROJECTION
Preparing For Projection
o Place the projector on a stable stand or table and face the projection l ens to
t he scr een.
Note:
8
Be sure to use a firm stand. If the projector is mounted on an
unsteady s urf ace such as a thin-board box, a possible resonance may
develop causing poor pro j ection performance.
8 Plug the power cord.
o Pull both reel arms up into position.
o Place your film on the front arm and the
take-up reel on the rear arm. Press the reel
lock s until the reels are snug against the
spindl es.