EM TEST RDS 200N User Manual

M a n u a l
f o r O p e r a t i o n
VDS 200 series
Voltage Drop Simulator pulses 2b, 4
 VDS 200N10, N15, N30 N50
 VDS 200N100, N150 N200
 VDS 200N30.1 N50.1
 VDS 200N100.1 N100.2 N100.3 N100.4
N100.5 N100.6
 VDS 200N150.1
 VDS 200N200.1 N200.2 N200.3 N200.4
 RDS 200N
Testing of electronic modules in 12V/24V or 42V supply
systems.
The VDS 200Nx is a low frequency amplifier. It simulates the
battery power supply of a vehicle and complex power supply
distortions in the power range up to 12'000W. A lot of different
waveforms are integrated as standard such as pulse 2b and
pulse 4 required in ISO 7637.
 ISO 7637
 SAE J1113
 Manufacturer spec
GM, Ford, Chrysler,
BMW, VW, PSA,
Renault, Fiat ....
Version:
5.19 / 03.09.2013
the benchmark for emc
Replaces:
5.18 / 17.06.2013
Filename:
UserManual-VDS200Nx-E-V519.doc
Printdate:
03.09.13

EM TEST RDS 200N Specifications

General

Brand	EM TEST
Model	RDS 200N
Category	Amplifier
Language	English

Summary

Model Overview

VDS Models

Details various VDS models and their specifications.

Special Models

Describes special VDS models with different voltage/current ranges.

Bipolar Models

Details bipolar VDS models and their specifications.

Operating Functions

Safety with Voltage Setting

Explains safety restrictions related to voltage settings.

Operation

Change of Parameters

Explains how to change parameters for test routines.

Wave Simulator

Standards

Lists standards supported by the Wave Simulator.

ISO 7637

Details ISO 7637 standard compliance.

ISO 16750-2 WD 03/2000-2

Details ISO 16750-2 and WD 03/2000-2 standards.

Supply Voltage Profile

Describes the supply voltage profile test.

Pulse 'Starting Profile'

Describes the pulse starting profile simulation.

Sinus Sweep

Describes the sinus sweep test.

Overvoltage Vmax

Describes the overvoltage Vmax test.

Jaso Test 1

Describes the Jaso Test 1 simulation.

Functions

Lists available functions for the Wave Simulator.

Sine Wave

Describes the sine wave generation function.

Jump Start

Describes the jump start simulation function.

VDS Extern via the Analogue Input

Explains external control via analogue input.

Pulse 4 (GM 9105 P)

Describes Pulse 4 with GM 9105 P ripple simulation.

DC Source

Setup

Test Equipment

Arbitrary Wave Simulator

Overvoltage Protection

Protection Voltage Level Setting

Function

Protection Levels

Level Settings by the User

Typical Protection Behavior

Technical Data

Test Level

Test Routines

Technical Data VDS 200N100.2

Technical Data VDS 200N100.6

DUT Voltage Limitation on DC Output

Voltage Attenuation at Sine Ripple Frequencies

Maintenance

Test Set-up with Software iso.control

Calibration and Verification

Factory Calibration

Describes the process and documentation of factory calibration.

Guideline to Determine the Calibration Period of EM Test Instrumentation

Periodically In-house Verification

RDS 200N

Technical Data RDS 200N