AIRPLANE
FLIGHT
NORMAL
PROCEDURES
ANAC APPROVED 3-09
REVISION 1 code 01 Page 3
Speedbrake Lever....................................................CLOSED
Thrust Levers ...........................................................IDLE
Gnd Prox Flap Ovrd .................................................CHECK
Audio Control Panel .................................................AS REQUIRED
Trims........................................................................CHECK/SET
Flight Controls Disconnect Handles.........................CHECK
Alternate Gear
Extension Compartment ..........................................CHECK
MCDU ......................................................................SET
Insert route in the FMS according to the flight plan.
--------------------------SHORTLY BEFORE STARTUP-------------------------
Fuel Quantity............................................................ CHECK
MCDU ......................................................................SET
− Select the TAKEOFF DATA SET MENU page on the MCDU.
Check if the performance data is consistent with the airplane
configuration and set the data below:
− Thrust Rate Mode (TO-1, TO-2 or TO-3).
− Takeoff Temperature (__ºC).
− ATTCS (ON or OFF).
− REF ECS (ON or OFF).
− REF A/I (OFF, ENG or ALL).
− FLEX T/O (ON or OFF).
− FLEX TEMP (__ºC).
− Select the TAKEOFF page on the MCDU. Set or verify airplane
configuration, performance data and takeoff speeds.