Embraer 190 - Normal Procedures; CAT II Approach

AIRPLANE
FLIGHT
MANUAL
SUPPLEMENT 3
CAT II OPERATION
CTA APPROVED S3-10
ORIGINAL code 01 Page 1
AFM
-
1912
NORMAL PROCEDURES
CAT II APPROACH
BEFORE INTERCEPTING LOCALIZER COURSE
- Set the RA/BARO Minimums Selector knob to RA.
- Perform the Descent/Approach/Before Landing checklists, as
appropriate.
- Set the CAT II Decision Height on both Display Control Panels.
- Test Radio Altimeter if only one is available.
- Select the same ILS frequency on MCDU.
NOTE: - If Radio Altimeter is checked not functioning properly the
CAT ll approach must be discontinued.
- A minimum distance of 4 NM to the Outer Marker is
recommended for interception and stabilization along the
approach course.
BEFORE INTERCEPTING THE GLIDE SLOPE
- Monitor radio altimeter information.
- Lower landing gear (one dot below GS interception) and set
flaps to 5.
- Set the Landing Reference Speed (V
REF 5
) on AP bug (cyan
bug).
- Stabilize and maintain the Landing Reference Speed (V
REF 5
).
- Set approach climb speed on FS reference speed bug (green
bug).
- Be sure that Marker Beacon audio is on.