AIRPLANE
FLIGHT
MANUAL
NORMAL
PROCEDURES
ANAC APPROVED 3-16
REVISION 3 code 01 Page 1
AFM-1912
TAKEOFF
(EMBRAER 190 MODELS)
Thrust Levers........................................................... TOGA
Engine Parameters.................................................. MONITOR
NOTE: During takeoff roll, after checking thrust levers to TOGA, check
N1 equal to N1 target and green ATTCS indication presented
on EICAS if ATTCS ON is selected in MCDU.
At V
R
rotate the airplane following the flight director guidance.
In case of flight director is inoperative rotate the airplane according to
the following schedule:
- For airplanes Pre-Mod. SB 190-31-0009:
FLAPS POSITION 1 2
3
4
PITCH ANGLE
11° 11° 9° 12°
- For airplanes Post-Mod. SB 190-31-0009 or equipped with an
equivalent modification factory incorporated, rotate the airplane
according to the takeoff pitch angle displayed on TAKEOFF page 3/3
on the MCDU.
With positive rate of climb:
Landing Gear...................................................... UP
Minimum Airspeed.............................................. V
2
+ 10