Embraer 190 - After Landing

SUPPLEMENT 4
RVSM OPERATION
AIRPLANE
FLIGHT
MANUAL
S4-10
CTA APPROVED
Page 2 code 01
ORIGINAL
AFM-1912
When altitude difference between PFD 1 and PFD 2 exceeds 100ft,
select ADS 3 on the PFD that does not agree with IESS.
AFTER LANDING
In case of failure or malfunction, the following information should be
recorded when appropriate:
− ADS 1, ADS 2, ADS 3 altimeter readings;
− Altitude selector setting;
− Baro Set value and Baro Set unit (InHg/HPa);
− Flight Director used with the Autopilot to control the airplane and
any differences when the other Flight Director was coupled;
− Use of air data system reversion for fault diagnosis procedure;
− The transponder selected to provide altitude information to ATC
and any difference noted when an alternative transponder was
selected.
EMERGENCY AND ABNORMAL PROCEDURES
The actions listed below must complement the procedures contained
in the basic AFM. The remaining Emergency and Abnormal
Procedures section remains unchanged.
− In case of emergency or abnormal situation or contingencies
(equipment failures, weather, etc.) which affect the ability to
maintain the cleared flight level, notify ATC and co-ordinate an
action plan that is appropriate to the airspace concerned;
− Notify ATC when encountering greater than moderate
turbulence;
− If unable to notify ATC and obtain an ATC clearance prior to
deviating from the cleared flight level, follow any established
contingency procedures and obtain ATC clearance as soon as
possible.