EMBRON Hatteland E Series - Page 126

126
Appendix
IND100077-218
BIOS Default Settings Overview
Chipset SATA
Disabled
SATA Mode Selection
[AHCI] *
SATA Port 0
xxx
SATA Port 1
xxx
USB Configuration
XHCI Pre-Boot Driver
[Enable]
[Disable] *
XHCI Mode
[Enable] *
[Disable]
USB VBUS
[Off]
[ON] *
USB HSIC1 Support
[Enable]
[Disable] *
USB SSIC1 Support
[Enable]
[Disable] *
USB Port Disable Override
[Disabled] *
[Enabled] Sub menu is visible only when this item is Enabled
USB Port #0
[Disable]
[Enable] *
USB Port #1
[Disable]
[Enable] *
USB Port #2
[Disable]
[Enable] *
USB Port #3
[Disable]
[Enable] *
USB Port #4
[Disable]
[Enable] *
USB Port #5
[Disable]
[Enable] *
USB Port #6
[Disable]
[Enable] *
USB Port #7
[Disable]
[Enable] *
USB 3 Port #0
[Disable]
[Enable] *
USB 3 Port #1
[Disable]
[Enable] *
USB 3 Port #2
[Disable]
[Enable] *
USB 3 Port #3
[Disable]
[Enable] *
USB 3 Port #4
[Disable]
[Enable] *
USB 3 Port #5
[Disable]
[Enable] *
XDCI Support
[Disabled] *
[PCI Mode]
XHCI Disable Compliance Mode
[FALSE] *
[TRUE]
Security>
Setup Administrator Password --
User Password --
Secure Boot
System Mode
User
Secure boot
Not active
Vendor Keys
Active
Attempt Secure Boot
[Disabled] *
Password Description
IF ONLY the administrator's password is set,
then this only limits access to Setup and is only asked for when entering Setup.
IF ONLY the User's password is set, then this is a power on password and must be entered to boot or enter
Setup. In Setup the User will have Administrator rights.
the password length must be in the following range:
Minimum length 3
Maximum length 20