EMC INDUSTRIAL GROUP LTD Setup
MW61A_IM_ALL_SV6.09d_en 15/47
Basic Settings
The basic settings are settings which generally must be set first and often affect other settings through
the controller. For example, they set the engineering units and measuring range for the application.
Inputs
The inputs are settings and calibration which effect the basic inputs signals. For example the loadcell
input, tacho input (where used) and digital inputs.
Internal Signals
This section contains the main calculations for the instrument. Most signals are here, for example the
weight, zero weight, total weight etc. Much of the instruments configuration is done in this section.
Outputs
The output are settings and calibration which effect the basic output signals. For example the 4-20mA
outputs and digital outputs. These change the calibration range and select the signal to appear on the
digital outputs.
Communications & Display
This section sets the baud rates etc for the communications ports. It sets the key locks for the
MD1,MD2 Display. It also contains the Macros for the instrument.
These settings are not available in ‘B’ model instruments.
Information, Resets & Final Calibration
This section contains information about the unit, including its serial number, the product type etc.
These settings allow all the settings & macros to be reset back to their default values. The final calibra-
tion is also done here.
Factory Settings
The factory settings are used to calibrate the basic instrument in the factory. These are password pro-
tected and are not usually required once the instrument has left the factory.
Keypad
MD1,MP1 Keypad
MD2,MP2 Keypad
SOFT keys
The function of the 5 soft keys is indicated on the display.
ALARM key
Used to access the alarm list menu.
SELECT key
Used to select a system to display if more than one unit is connected on the network.
DISPLAY key
Allows the operator to select the display layout.
ALARM
SELECT
DISPLAY
SETUP
UP
LEFT
RIGHT
DOWN
SOFT KEYS
BACK
ENTER
SOFT KEYS
BACK
ENTER
ALARM
SELECT
DISPLAY
SETUP
UP
LEFT
RIGHT
DOWN
To Next Page
Loading...