EMC ModWeeihg MW61A - Instrument Keys and Navigation; Physical Key Functions Overview; Menu Navigation Key Usage

EMC INDUSTRIAL GROUP LTD Keys
MW61A_IM_ALL_SV6.09d_en 44/47
Identification of selected unit. Press SELECT ( ) to view and select another unit from list of
units connected.
Alarm Symbol flashes when an alarm is present.
Main display bar graph. Shows the displayed weight. The indicators show
the positions of the low and high setpoints.
Main display of measured value. Normally weight.
A group of annunciators described below.
L1
Limit 1 indicator. A high limit by default.
L2
Limit 2 indicator. A low limit by default.
GROSS
Gross weight bar graph.
Limit 1 active.
Limit 2 active.
Gross weight
Net weight
Motion
Tare acquired by push button
Tare value enter with keypad
Weight at centre of zero
Weight within zero band
Engineering unit main display is calibrated in.
Secondary display shows one of a selection of values. Press the key to scroll through the
list.
Shows functions of soft keys A to E.
Keys
operator menu
Press the OK (tick) key to reach the operator menu. See the Operator Menu section below for details.
alarm menu
Press the ALARM key to reach the alarm menu. See the Alarm Menu section below for details
system select menu
Press this key to view and select another unit from list of units connected.
scroll display
Press this key to select the next line at the bottom of the display.
soft keys A – E
The function of the soft keys is shown in the display. These are shortcuts to items in the operator
menu.
cancel
Press this key to cancel an entry or back up a menu. When in any of the menus, holding this key down
for 2 seconds will exit back to the operator status display.
9
8
7
5
4
3
2
1
3
2
7
1
4
5
8
9