EMC ModWeeihg MW61A - Adjusting Settings and Menu Types; Procedure to Adjust a Setting; Service and Altered Settings Menus

EMC INDUSTRIAL GROUP LTD Setup
MW61A_IM_ALL_SV6.09d_en 17/47
Service
Service menu contains all standard settings as well as settings for advanced configuration and diagnos-
tics. Use this menu if there are special application requirements, or if special diagnostics are required.
This menu includes the Factory settings, for which certified equipment is required. These settings are
not documented in this manual, contact the factory for further information.
Altered settings
Altered settings menu lists all settings that are different from the default. Use this menu to fill in the
field settings on the Setup Summary
To Adjust A Setting
Press the EDIT key to allow changes to the selected setting.
If editing is locked, a password will be requested. For Quick setup and Main setup, the password is
111. For Service setup the password is 9713. For Altered setup there is no password as settings are
display only.
Use the keypad and/or UP and DOWN arrow keys to increase or decrease the displayed setting. Some
settings allow only one method, and some are display only.
Holding either key down will automatically continually increase or decrease the value.
1
Menu item.
2
Setting name.
3
Gives information about the settings and indicates active keys or the preferred method of making a
value change while editing.
Icon Description
The setting is locked. Password must be entered to edit.
The setting can only be viewed.
The setting has been changed from the default.
An important setting.
The setting is being edited.
Use numbered keys to change setting value.
Use UP & DOWN keys to scroll through selection list.
Use UP & DOWN keys to turn setting on or off.
Use the arrow keys to move through the bits of a control or status register.
4
Sequence of quick-keys used to reach this setting. Not editable. The left-most digit identifies the
current menu as follows: 1 for Quick setup, 2 for Main setup, 3 for Service setup, and 4 for Altered
setup.
5
Hint line which reveals extra information about the setting.
6
Setting value. To change press EDIT key. If editing is locked, a password will be requested. Key in
the password and press the ENTER key. The setting will become highlighted by a black back-
ground. Key in changes then press ENTER key. For Quick setup and Main setup, the password is
111. For Service the password is 9713.
7 Engineering unit setting is displayed in.
8
Modbus address of this setting. Not editable.
9
Soft keys used with settings.
Icon Description
Press key for menu of special functions.
Press EDIT key to edit the macro.
Use the soft key to start and stop an operation.
1
5
3
2
7
8
4
6
9