32
Reference Manual
00809-0200-4420, Rev HC
Section 4: Commissioning
July 2015
Commissioning
4.4.1 Setup
In the Security Setup Utility add a new proxy for each Gateway based on the communication
protocol that is being used. For example, add an OPC proxy for each Gateway that is
communicating OPC.
Use the following procedure to add a new proxy in the Security Setup Utility:
1. Open the Security Setup Utility.
2. Select EDIT>NEW, then select the type of new proxy to be added.
3. Right click on the new proxy entry and select Properties.
4. Enter the target Gateway’s Hostname and IP Address.
5. Select OK.
6. Select FILE>SAVE.
7. When prompted for authentication, enter the admin password for the target Gateway.
8. Select OK.
9. Repeat Step 2-Step 8 to added additional proxies.
10. Select FILE>EXIT to close the Security Setup Utility.
During this process, the Gateway will exchange security certificates (digital signatures) with the
proxy.
Figure 4-2. Security Setup Utility
To Next Page
Loading...
