EasyManuals Logo

Emerson Bettis XTE3000 Maintenance Instruction

Emerson Bettis XTE3000
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
February 2022
17
Alarm "Conguration n°"
Section 4: Alarm "Conguration n°"
Table 3. EFS / PST
Actuator Setup
Obj n° Value Function Description
800 Off EFS action in case of voltage failure
On/Off selector to perform safe action if main
voltage of actuator fails. Not used for XTE3000.
801 Off EFS action in case of selector in OFF
On/Off selector to perform safe action if local
selector of actuator is in OFF. Not used for XTE3000.
802 On Auto-reset
On/Off selector to re-energize the clutch after the
configured time
810 30 Reset-delay Time to re-energize the clutch
811 360 PST period Period of PST in days
812 12 PST hour Time of PST in hours
813 10 PST travel Travel of PST in % of stroke
814 100 Max. T-PST% Max. T-PST in % of reference
816 Manual PST mode Selector Off/manual/man-auto/auto
817 100 Max. T-RET% Max. T-RET in % of reference
818 1 PST pause Pause time
819 100 Max. OV-TR% Max. over-travel in % of stroke
Table 4. Remote and Local Controls
Actuator Setup
Obj n° Value Function Description
121 Off Remote control type
Off, 4 wires latched, 3 wires push to run, 3 wires instant
reverse, 2 wires open if signal off, 2 wires open if signal on
120 Latched Local control type
Latched, push to run, latched instant reverse,
push-to-run relAs5-6
1 On Close led color Closed led color=ON=red, OFF=green
2 Off Open led color Open led color=ON=red, OFF=green
3 On Alarm led color Alarm led color=ON=yellow, OFF=red
30 Off Remote stop type Remote stop active if signal is on=make or off=break
Output Relays
Table 5. Monitor Relay
Actuator Setup
Obj n° Value Function Description
201 Enabled Local STOP pressed Enabled, disabled
202 Enabled Local OFF Enabled, disabled
203 Enabled ESD - EFS Enabled, disabled. Not used for XTE3000.
204 Enabled Manual operation Enabled, disabled
206 Enabled Motor high temperature alarm Enabled, disabled
207 Enabled High torque alarm Enabled, disabled
208 Enabled Jammed valve alarm Enabled, disabled
209 Enabled Low battery alarm Enabled, disabled

Other manuals for Emerson Bettis XTE3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Emerson Bettis XTE3000 and is the answer not in the manual?

Emerson Bettis XTE3000 Specifications

General IconGeneral
BrandEmerson
ModelBettis XTE3000
CategoryController
LanguageEnglish

Related product manuals