100-412-196 REV. 06 19
ESC Key
Press the ESC key to return without saving weld mode, parameter, or
register changes.
Alarm Reset Key
Press the Alarm Reset key to reset alarms.
Mode/Configuration Key
Press one time to modify Weld settings. For information on modifying
weld settings see 6.2 System Modes.
Press a second time to select a configuration register. For information on
configuring the system registers see 6.4 System Configuration
Registers.
Press a third time to return to the ready state.
Test Key
Press and hold Test key to turn on sonics. Test performs a seek and then
ramps the amplitude to the current setting.
Start/Stop Key
Press and hold Start/Stop key to turn ultrasonics on. By Default, the
user must continue to hold the Start/Stop key throughout the duration
of the process cycle. To configure as a start/stop toggle switch see 6.4
System Configuration Registers.
Table 2.1 Front Panel Controls and Indicators
Reference Description
To Next Page
Loading...
