42 100-412-196 REV. 06
5.5 Electrical Connections to Equipment
All of the connections to the LPX Power Supply are made to the rear of the unit using
industry-standard connectors. Refer to Figure 2.3 for connector locations.
5.5.1 Power Cord
North American units are shipped with a 3-conductor 117 Volt cordset (NEMA 5-15P to IEC
jack). It connects to an IEC-type connector on the rear of the unit. The plug end connects
to your main voltage receptacle, which should be properly fused (depending on your site
requirements). It requires a conventional NEMA 5-15R receptacle for installation.
All units are shipped with a standard Harmonized cordset having an IEC-type jack.
WARNING High Voltage Hazard
If your cordset does not match your main power receptacle, verify
that you have the correct voltage available. Do not connect the
system if the voltage rating of the unit is incorrect for your location,
as this can damage the unit and void warranty.
To Next Page
Loading...
