Emerson Bristol 2808 Series - Page 50

2-4 / Installation 2808B
* The device may be an indicator, recorder, tone modulator, etc.
*
1
Connect the shield to earth ground or to a shield terminal on the device, if so equipped.
*
2
Refer to Figure 3-2 and set the Jumper Block for Current Operation.
Figure 2-2 - Transmitter Wired to Instrument Supply Source (4-20mA Circuit)
* The device may be an indicator, recorder, tone modulator, etc.
*
1
Connect the shield to earth ground or to a shield terminal on the device, if so equipped.
*
2
Refer to Figure 3-2 and set the Jumper Block for Current Operation.
Figure 2-3 - Transmitter Wired to External DC Supply (4-20mA Circuit)