Emerson Bristol 2808 Series - Page 51

2808B Installation / 2-5
* The device may be an indicator, recorder, tone modulator, etc.
*
1
Connect the shield to earth ground or to a shield terminal on the device, if so equipped.
*
2
Refer to Figure 3-2 and set the Jumper Block for Voltage Operation.
Figure 2-4 - Transmitter Wired to Instrument Supply Source (1-5V Circuit)
* The device may be an indicator, recorder, tone modulator, etc.
*
1
Connect the shield to earth ground or to a shield terminal on the device, if so equipped.
*
2
Refer to Figure 3-2 and set the Jumper Block for Voltage Operation.
Figure 2-5 - Transmitter Wired to External DC Supply (1-5V Circuit)