Emerson Daniel 3410 Series Installation Manual

Shroud hanging on Shroud pinFigure 3-26:
3. Bring up the mating shroud, ensuring the transducer cabling falls within and is snug
in the shroud recess as before and hold in place.
4. Latch first the bottom shroud latch(s) followed by those on the upper side of the
shroud.
5. Thread the security seal's wire through the holes found on the latching lever side of
the mechanism and then through the seal mechanism itself. Pull the wire taught
then rotate the cranking tab until it snaps off.
Electrical installation
Installation manual 83

Emerson Daniel 3410 Series Specifications

General

Brand	Emerson
Model	Daniel 3410 Series
Category	Measuring Instruments
Language	English