Emerson E Series - Page 7

Declaration of Conformity
Manufacturer's Name:
Manufacturer's Address:
Products Description:
Model Number:
System Options:
EMERSON Mol Mn Control
1365 Park Oral
Chanhassen, MN 55317
lSA
Declares That The Following Products:
E Series Digital Servo Drtve
EN-204. EN 208, EN 214
This declaration covers the above products with the
Al.P-130 Backup Logic Power Supply and EC1-4-1 Screw
Term i nal Interface.
Designed and manufactured In accordance with the following European harmonized
national and International standards.
Electomagnetie Compatibility_
EN 55011,1991 Class A (1roup I. CISPR 11/1990 China A Group I
EN 50082.2/1995.
IEC 1000-4-2/1995. EN 61000-4-2, .1kV CD
IEC 1000-4-3/1995, EN 61000-4.3, ENT 50140/1993.
80% AM. 10‘61n (ii 3 ni
IEC 1000-44/1995, EN 61000.4-4. 2 kV ALI, LINES
I EC 1000-4.8/1993; EN 61000.4-8, 30 Aim
ENV 50141/1993, 80% AM, 10V, 15.80 MHz
ENV 50204/1995, Puke, 900 MHz, 50% I)TY. 200 Hz
Supplementary Information
The products herewith comply with the requirements of the Low Voltage Directive (IND) 73/23/EEC
sod EMS' Directive 89/33C,/EEC
This electronic drive product is intended in lie used with an appropriate motor, electrical protection components
and other equipment to form a complete end product or system. It must only be installed by a professional
assembler who is familiar with requirements for safely and elet7tromagnetic compatthility ("EMC"). The
assembler is responsible for ensuring that the end product or system complies with all the reles-ant laws in the
country where it is to he used Refer to the prodot I manual for installation guidelines.
December 2, 1997
Bradley Schwartz/ VP Engineering Date
European Contact
Sobel. Automation
Langeseldpark Lot Ill
I' Dasterleussrast 2
101(0 Si Pieters fret, Bel, ono
V