Emerson IC200CX EVO - Modify the Set Point

IC200CXEVO
usermanual
16
6.2Modifythesetpoint
Themodificationofthesetpointisonlypossibleforthecurrentunitmode(chillerorheatpump)and
fordomestichotwatermanagementifactive.
Pressforatleast3seconds.
ThedisplaywillshowSetCorSetHdependingon
theoperatingmodeinthelowerline.Theblinking
valueofthesetsetwillbedisplayedintheupper
line.
Usethekeysandtomodifythe
setpointvalue.
Toconfirmthenewsetpoint,pressorwait
forthetimeouttoexitprogramming.
3seconds
Whentheunitisoperating:whenthebuttonispressedforthefirsttime,thelowerdisplay
showsSEtC(setchiller)orSEtH(setheatpump),dependingontheunitmode,andtheupperdisplay
showsthesetvalue.Pressingagain,withtheenergysavingorwiththedynamicsetpointactivated
(par.6.3),thelowerdisplayshowsthelabelSEtr(realset)andtheupperdisplayshowstheactual
workingsetpointoftheunit.Pressthebuttonagaintodisplaythedomestichotwatersetpoint
SEtS(ifthefunctionisactivated).