Emerson IC200CX EVO - How to Enter in Programming Mode in Levels Pr2­Pr3; How to Change the Value of a Parameter

IC200CXEVO
usermanual
37
10.3HowtoenterinprogrammingmodeinlevelsPr2Pr3
Simultaneouslypresstheandbuttons
for3sec;theupperdisplayshowsthePASlabeland
thelowerdisplayshowsthe"Pr1"label(levelPr1).
Pressandholdthekeyfor3seconds,thelabel
"Pr2"willappearonthelowerdisplay(Pr2level).
3seconds
Pressandholdthekeyforanother3seconds,
thelabel"Pr3"willappearonthelowerdisplay(Pr3
level).
3seconds
3seconds
10.4Howtochangethevalueofaparameter
Entertheparameterprogrammingasdescribedinthe
previousparagraphs,usethearrowkeystoselectthe
desiredparametergroup(egStthermoregulation
parameters).Confirmwith.
Thefirstparameteroftheselectedgroupwillappear,
withitscurrentvalue.
Thepasswordisenteredasinthecaseofaccesstothe
parameterlevelPr1.