Emerson IC200CX EVO - 10 Parameter Programming; Programming from Keyboard; How to Enter in Programming Mode in Level Pr1

IC200CXEVO
usermanual
35
PARAMETERPROGRAMMING
10
10.1Programmingfromkeyboard
Thevaluesofalltheparameterscanbechangedthroughthekeypad.Theparametersofthe
controllerhavebeengatheredintofamilies,eachofwhichisidentifiedwithalabel.Thisenablesthe
usertoquicklyaccesstheparametersconcernedinthevariouslevels.
• ALL Allparameters
• St Thermoregulationparameters
• CF Configurationparameters
• Sd Dynamicsetpointparameters
• ES Doublesetpointparameters
• Cr Compressorcontrolunitparameters(notused)
• CO Compressor/pumpparameters
• US Auxiliaryoutputparameters
• FA Fanparameters
• Ar Antifreezeheaterparameters
• Df Defrostparameters
• FS Domestichotwatermanagementparameters
• AL Alarmparameters
Thereare3parameterprogramming/editinglevels:
1.Pr1userlevel(commonparameters);
2.Pr2customersupportlevel(unitsettings,reservedforService);
3.Pr3manufacturerlevel(unitconfiguration,reserved).
10.2HowtoenterinprogrammingmodeinlevelPr1
Simultaneouslypresstheandbuttons
for3sec;theupperdisplayshowsthePASlabeland
thelowerdisplayshowsthePr1label(levelPr1).
Pressthebuttonandthenthe0willstartto
flashontheupperdisplay.
3seconds