Emerson IC200CX EVO - Parameters Backup and Restore with Hot Key; Visualisation of Compressors and Pumps Operating; Visualisation of Compressors Starts up; Visualisation of Compressors Discharge Temperature

IC200CXEVO
usermanual
27
UsingtheUPLmenu,theinstrumentparameterscan
bestoredina"HotKey"programmingkey.Thekey
mustbeinsertedwhentheinstrumentisswitchedon.
Pressingthekeythecontrollerstartscopying
thedata;theUPLlabelisflashing.Whenthe
procedureiscompleted,theENDmessageis
displayedconfirmingthatthecopyhasbeencorrectly
executed,orErrincaseoferrors.
ThroughtheCOSnmenuitispossibletodisplaythe
numberofcompressorsstartsup.Theindividual
compressorsareidentifiedbytheC1SandC2Slabels.
ThroughtheCOdtmenuitispossibletodisplaythe
temperaturevalueoftheprobesthatcontrolthe
compressordischargetemperature.
•dischargetemperaturecompressorn°1(CO1t)
•dischargetemperaturecompressorn°2(CO2t)
Note:thestartsupareshownintheupperdisplaywitharesolutionof10(thevalue2indicates
thatthestartsupare20).
ThroughtheHourmenuitispossibletoviewthe
operatinghoursofthecontrolledloads:
•compressorsoperatinghours(CO1H/CO2H)
•mainpumpoperatinghours(EP1H)
•sanitarywaterpumpoperatinghours(SAPH)
Note:thehoursofoperationareshownintheupperdisplaywitharesolutionof10hours(the
value2indicatesthatthehoursofoperationofthatloadare20).
8.4Parametersbackupandrestorewith"HotKey"
8.5Visualisationofcompressorsandpumpsoperatinghours
8.6Visualisationofcompressorsstartsup
8.7Visualisationofcompressorsdischargetemperature