Emerson Micro Motion 1000 Series

184 Micro Motion Series 1000 and Series 2000 Transmitters
Menu Flowcharts – Model 1500 AN Transmitters
Figure C-3 ProLink II configuration menu continued
Figure C-4 ProLink II configuration menu continued
T Series
• FTG
• FFQ
•DTG
•DFQ1
•DFQ2
•K3
•D3
•D4
•K4
ProLink >
Configuration
Special Units
• Base mass unit
• Base mass time
• Mass flow conv fact
• Mass flow text
• Mass total text
• Base vol unit
• Base vol time
• Vol flow conv fact
• Vol flow text
• Vol total text
Device
•Tag
•Date
•Descriptor
• Message
• Sensor type
• Transmitter serial number
• Floating pt ordering
• Add comm resp delay
Digital comm settings
• Fault setting
• HART address
• Loop current mode
• HART device ID
• Modbus address
• Enable write protection
Update rate
• Update rate
•100 Hz variable
Burst setup
• Enable burst
• Burst cmd
• Burst var 1...4
Events
• Event 1/2
•Variable
•Type
•Setpoint
Discrete events
•Event name
•Event type
• Process variable
• Low setpoint (A)
• High setpoint (B)
Polled variables
Polled variable 1/2
• Polling control
•External tag
• Variable type
• Current value
Alarm
•Alarm
• Severity
Additional configuration options
Discrete input
• Assignment
• Polarity
Sensor simulation
• Enable/disable
Mass flow
• Wave form
•Fixed value
•Period
•Minimum
•Maximum
Density
• Wave form
•Fixed value
•Period
•Minimum
•Maximum
Temperature
• Wave form
•Fixed value
•Period
•Minimum
•Maximum
ProLink >
Configuration
Transmitter options
• Volume flow
• Meter fingerprinting
• Meter verification
Variable mapping
•PV is
•SV is
•TV is
•QV is
System
• W & M approval
• Reset options
Sensor
• Sensor s/n
•Sensor model
•Sensor matl
• Liner matl
•Flange