84 Micro Motion Series 1000 and Series 2000 Transmitters
Optional Configuration
A108
(7)
Event #1 Triggered Info Yes No
Event 1 Triggered
A109
(7)
Event #2 Triggered Info Yes No
Event 2 Triggered
A110
Frequency Output Saturated
Info Yes
(6)
No
Frequency Output Saturated
A111 Frequency Output Fixed Info Yes
(6)
No
Frequency Output Fixed
A112
(8)
Software Upgrade Recommended Info Yes No
S/W Upgrade Recommended
A113 Secondary mA Output Saturated Info Yes
(6)
No
Secondary mA Output Saturated
A114 Secondary mA Output Fixed Info Yes
(6)
No
Secondary mA Output Fixed
A115 External Input Error Info Yes No
External Input Error
A116 API Temperature Out-of-Limits Info Yes No
API: Temperature Outside Standard Range
A117 API Density Out-of-Limits Info Yes No
API: Density Outside Standard Range
A118 Discrete Output 1 Fixed Info Yes
(6)
No
Discrete Output 1 Fixed
A119 Discrete Output 2 Fixed Info Yes
(6)
No
Discrete Output 2 Fixed
A120 ED: Unable to fit curve data Info No No
ED: Unable to Fit Curve Data
A121 ED: Extrapolation alarm Info Yes No
ED: Extrapolation Alarm
A131
(3)
Meter Verification Info Alarm Info Yes No
Meter Verification/Outputs at Last Value
A131
(4)
Meter Verification in Progress Info Yes No
Meter Verification In Progress
A132
(2)
Simulation Mode Active Info Yes
(6)
No
Simulation Mode Active
(1) Applies only to systems with the standard core processor.
(2) Applies only to systems with the enhanced core processor.
(3) Applies only to systems with the original version of the meter verification application.
(4) Applies only to systems with Smart Meter Verification.
(5) If outputs are set to Last Measured Value, severity is Info. If outputs are set to Fault, severity is Fault.
(6) Can be set to either Info or Ignore, but cannot be set to Fault.
(7) Applies only to events configured using the single-setpoint event model.
(8) Applies only to systems with transmitter software earlier than rev5.0.
Table 8-8 Status alarms and severity levels continued
Alarm code
Communicator message
Default
severity Configurable
Affected by
fault timeoutProLink II message
To Next Page
Loading...
