Emerson Micro Motion 1000 Series

Configuration and Use Manual 83
Optional Configuration
Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup
A024
(1)
(E)EPROM Program Corrupt (Core Processor) Fault No No
(E)EPROM Program Corrupt (CP)
A025
(1)
Protected Boot Sector Fault Fault No No
Protected Boot Sector Fault (CP)
A026 Sensor/Xmtr Communication Error Fault No No
Sensor/Transmitter Communication Error
A027 Security Breach Fault No No
Security Breach
A028 Sensor/Xmtr Communication Failure Fault No No
Core Processor Write Failure
A031
(2)
Undefined Fault No No
Low Power
A032
(3)
Meter Verification Fault Alarm Fault No No
Meter Verification/Outputs In Fault
A032
(4)
Outputs Fixed during Meter Verification Varies
(5)
No No
Meter Verification In Progress and Outputs
Fixed
A033
(2)
Sensor OK / Tubes Stopped by Process Fault Yes Yes
Sensor OK/Tubes Stopped by Process
A034
(4)
Meter Verification Failed Info Yes No
Meter Verification Failed
A035
(4)
Meter Verification Aborted Info Yes No
Meter Verification Aborted
A100 Primary mA Output Saturated Info Yes
(6)
No
Primary mA Output Saturated
A101 Primary mA Output Fixed Info Yes
(6)
No
Primary mA Output Fixed
A102 Drive Over-Range / Partially Full Tube Info Yes No
Drive Overrange
A103
(1)
Data Loss Possible Info Yes No
Data Loss Possible (Tot and Inv)
A104 Calibration-In-Progress Info Yes
(6)
No
Calibration in Progress
A105 Slug Flow Info Yes No
Slug Flow
A106 Burst Mode Enabled Info Yes
(6)
No
Burst Mode Enabled
A107 Power Reset Occurred Info Yes No
Power Reset Occurred
Table 8-8 Status alarms and severity levels continued
Alarm code
Communicator message
Default
severity Configurable
Affected by
fault timeoutProLink II message