3.2.2 Orienting the display board
The display board can be rotated 90 degrees, clockwise or counterclockwise, from the
original position. To reposition the display:
1. Loosen the cover lock nut until the tab disengages from the circuit end cap. Unscrew
the cap.
2. Remove the three bolts holding the circuit board stack.
3. Lift and rotate the display board 90 degrees, clockwise or counterclockwise, into the
desired position.
4. Position the display board on the stand offs. Replace and tighten the bolts.
5. Replace the circuit end cap.
3.2.3 Mounting on a flat surface
Mounting 5081 on a flat surfaceFigure 3-1:
3.2.4 Mounting on a pipe
Use pipe mounting kit (23820-00 or 23820-01).
Installation
12 Rosemount 5081
To Next Page
Loading...
