Disabling fault annunciationFigure 8-8:
Non-disabling warnings
When a non-system-disabling condition occurs, a warning message is displayed.
The process variable does not flash. The appropriate message alternates with the
Temperature/Current output display (see Figure 8-9).
If more than one fault exists, the display will sequence through each diagnostic message.
This will continue until the cause of the fault has been corrected.
Warning annunciationFigure 8-9:
8.2.3 Diagnostic messages
The 5081 transmitter's diagnostics constantly monitor the conductivity loop for possible
problems. If an operational problem is encountered, check the display for a fault or error
message. These are displayed in the Temperature/Current output segment of the display.
Note the message and refer to Table 8-3 for a description of possible problems that may
have triggered the diagnostic message.
Diagnostics and troubleshooting
Instruction Manual 83
To Next Page
Loading...
