9. Use the arrow keys to change the setting.
The range is 0 to 225.
10. Press ENTER to save.
The screen displays the TEST prompt.
11. Use the arrow keys to enter the desired test current. Press ENTER to start the test.
Press EXIT to end the test.
12. Press RESET to return to the main display.
6.3 Temperature correction
1. Press PROG. Press NEXT until the TEMP submenu appears on the display.
2. Press ENTER.
The screen displays the T AUTO prompt.
3. Use the up or down arrow keys to enable (ON) or disable (OFF) the automatic
temperature correction feature. Press ENTER to save.
The T MAN prompt is displayed.
Programming - basics
Instruction Manual 35
To Next Page
Loading...
