6 Programming - basics
6.1 5081 programming
The following can be programmed in the 5081:
1. 4-20 mA outputs
2. Current generated by the transmitter during hold
3. Current generated by the transmitter when fault is detected
4. Automatic temperature correction (enable or disable)
5. Type of measurement
6. Measurement range
7. Factory default setting
6.2 4-20 mA outputs and current generated during
hold and faults
1. Press PROG on the remote controller.
The OUTPUT submenu appears.
2. Press ENTER.
The screen displays the 4mA prompt.
3. Use the arrow keys to change the setting. Press ENTER to save.
The screen displays the 20mA prompt.
Programming - basics
Instruction Manual 33
To Next Page
Loading...
