Emerson X-STREAM Series

Emerson Process Management GmbH & Co. OHG 2-15
X-STREAM Non-Incendive
Instruction Manual
HASXENE-IM-EX
12/2014
2
Installation
This connector is standard for X-STREAM
Enhanced.
To install this connection, a cable must be
fed through the cable entry without a con-
nector.
The connector can be wired on when the free
end has been fed into the instrument:
We recommend the VARIOSUB RJ45 QUICK-
ON connector (PHOENIX CONTACT), which
is supplied with the unit and requires no spe-
cial tools. Wiring instructions can be found
in the separate manual supplied with the
connector.
RJ45 Ethernet connection
Fig. 2-7: Ethernet Connector
Pin 1 Pin 8
Pin no. Signal
1 TX+
2 TX-
3 RX+
6 RX-
other not used
2.7 Installation - Electrical