Emerson X-STREAM Series

Emerson Process Management GmbH & Co. OHG3-20
X-STREAM Non-Incendive
Instruction Manual
HASXENE-IM-EX
12/2014
3.9 Checking the Settings
Press
LEFT to return to SETUP, and then open
IN/OUTPUTS. and from there enter ANALOG
OUTPUTS.
3.9.4 Setting the Analog Outputs
Select the analog output you like to check.
Note!
The following section only in brief describes
the entries currently of interest!
X-STREAM XE instruction manual,
Chapter 6 for a more detailed description.
Setup..
In/Outputs..
Analog outputs..
"Signal” specifi es the value associated with
the selected output. The following options
(partly dependent on the number of measu-
ring channels and sensors installed) are
available:
Analog Outputs
Output1..
Output2..
Output3..
Output4..
Output5..
Signal: Comp1
OutRange: 0-20 mA
Low Scale: 0.00
Max Scale: 100.00
AutoScale: Yes
FailMode: Live
0/4 mA: 0.00
20 mA: 100.00
Hold: No