EMKO EAOM-210 FLJ - Page 116

EAOM-210 FLJ.eng / ver 0.0
Pages 116 / 132
• FMI1 – Failure mode identifier-1 (Active Faults DM1 with the Multipacket
Transport via J1939)
• OC1 – Occurrence count-1 (Active Faults DM1 with the Multipacket Transport via
J1939)
• SPN2 – Suspect parameter number-2 (Active Faults DM1 with the Multipacket
Transport via J1939)
• FMI3 – Failure mode identifier-2 (Active Faults DM1 with the Multipacket
Transport via J1939)
• OC2 – Occurrence count-2 (Active Faults DM1 with the Multipacket Transport via
J1939)
• SPN3 – Suspect parameter number-3 (Active Faults DM1 with the Multipacket
Transport via J1939)
• FMI3 – Failure mode identifier-3 (Active Faults DM1 with the Multipacket
Transport via J1939)
• OC3 – Occurrence count-3 (Active Faults DM1 with the Multipacket Transport via
J1939)
13- Event Logs Page:
EVENT LOG 1
20/03/2009 15:21:38
EMERGENCY STOP ERROR
AUTO CRANKNG ATTEMP
OVER SPEED PREALARM!
• EMERGENCY STOP ERROR - This message indicates that an emergency stop
alarm has occured. (Event history: 20/03/2009 date, 15:21:38 time). Events
(from 1 to 32) can be displayed sequencely with the button. Possible Event
messages are:
AMBER WARNING LAMP: J1939 Amber Warning Lamp error
BATTERY HIGH ERROR: Battery high voltage alarm
BATTERY LOW ERROR: Battery low voltage alarm
CAN BUS ERROR: Can Bus error
CHANGED MODE TO AUTO: Changed mode to auto
CHANGED MODE TO MAN: Changed mode to manual
CHANGED MODE TO OFF: Changed mode to off
CHANGED MODE TO TEST: Changed mode to test
CHARGE ALTERNTR FAIL: Charge alternator fail
EARTH FAULT ALARM: Earth fault alarm
EMERGENCY STOP ERROR: Emergency stop error
EXPAN.SPARE-1 ERROR: Expansion Spare-1 error
EXPAN.SPARE-2 ERROR: Expansion Spare-2 error
EXPAN.SPARE-3 ERROR: Expansion Spare-3 error
EXPAN.SPARE-4 ERROR: Expansion Spare-4 error
EXPAN.SPARE-5 ERROR: Expansion Spare-5 error
EXPAN.SPARE-6 ERROR: Expansion Spare-6 error
EXPAN.SPARE-7 ERROR: Expansion Spare-7 error
EXPAN.SPARE-8 ERROR: Expansion Spare-8 error