EAOM-210 FLJ.eng / ver 0.0
Pages 6 / 132
• Engine Rpm
• Load Amps (IL1, IL2, IL3, IT)
• Earth current (IEA)
• Engine Oil pressure
• Coolant temperature
• Fuel Level
• Battery voltage
• Charge generator voltage
• Real Time
• Engine run time
• Next maintenance hour
• Next maintenance month
• Number of engine runs
• Number of engine starts
• J1939 values (speed, oil pressure, coolant temperature and working hour)
• J1939 SPN and FMI (Active Faults DM1 via J1939)
• J1939 SPN1, FMI1 and OC1 (Active Faults DM1 with the Multipacket Transport via
J1939)
• J1939 SPN2, FMI2 and OC2 (Active Faults DM1 with the Multipacket Transport via
J1939)
• J1939 SPN3, FMI3 and OC3 (Active Faults DM1 with the Multipacket Transport via
J1939)
• Error messages (if available)
• Event Logs
• Working modes
• Program parameters
The unit is extensively programmable through the front panel, with password protection on
two levels. Operational parameters can also be monitored and controlled from a PC via a
built-in RS232 port.
If the engine fails to start on the first attempt, further attempts are made up to a
programmed number of times or until successful.
If a fault is detected, the unit shuts down the engine and indicates the failure by flashing a
relevant fault LED.
Emergency stop input provide for remote control of the engine.
The user configurable inputs 4 and 5 can be programmed to perform 26 different functions.
Other four user configurable inputs can be programmed to perform 25 different functions.
Four user configurable relay outputs can be programmed for 95 different functions.
To Next Page
Loading...
