34
REMOVING AIR FROM WATER QUALITY SYSTEM
is a common error code that may appear on the keypad during the initial start up of the pool as a result of air
trapped in the plumbing lines.
1. Shut off the power to the pool equipment.
2. Close Ball Valve (A) on the return side of the plumbing. Ball Valve (B) should be left in the open position.
3. Cover the Circulation Pump (C) with a towel to prevent it from getting wet. Partially crack open Union (D). This
will allow any air trapped in the plumbing to escape. Once all air has been released, tighten the Union, open Ball
Valve (A), and re-supply power to the equipment. Allow up to 5 minutes for the controller to fully reboot.
Fig. 56
To Next Page
Loading...
