Commissioning Deltabar S FOUNDATION Fieldbus
34 Endress+Hauser
6.5.2 Information on level measurement
!
Note!
• The Flow, Level and Pressure operating modes each have a quick setup menu which guides
you through the most important basic functions. See Page 37 for the "Level" quick setup
menu.
• Furthermore, the three level modes "Level Easy Pressure", "Level Easy Height" and "Level
Standard" are available to you for level measurement. You can select from the "Linear",
"Pressure linearized" and "Height linearized" level types for the "Level Standard" level mode.
The table in the "Overview of level measurement" section below provides an overview of the
various measuring tasks.
– In the "Level Easy Pressure" and "Level Easy Height" level modes, the values entered are
not tested as extensively as in the "Level Standard" level mode. The values entered for
EMPTY CALIB./FULL CALIB., EMPTY PRESSURE/FULL PRESSURE and EMPTY
HEIGHT/FULL must have a minimum interval of 1% for the "Level Easy Pressure" and
"Level Easy Height" level modes. The value will be rejected with a warning message if the
values are too close together. Further limit values are not checked; i.e. the values entered
must be appropriate for the sensor and the measuring task so that the measuring device can
measure correctly.
– The "Level Easy Pressure" and "Level Easy Height" level modes encompass fewer
parameters than the "Level Standard" mode and are used for quick and easy configuration
of a level application.
– Customer-specific units of fill level, volume and mass or a linearization table may only be
entered in the "Level Standard" level mode.
• For a detailed description of the parameters and configuration examples, see Operating
Instructions BA00303P "Cerabar S/Deltabar S/ Deltapilot S, Description of Device
Functions".
To Next Page
Loading...
Need help?
General
