Deltabar S FOUNDATION Fieldbus Operation
Endress+Hauser 31
P01-xMx7xxxx-05-xx-xx-xx-005
Fig. 8: Typical Deltabar S display in a configuration program after the connection has been established
1Device name
2 Serial number
6.4 Local operation – onsite display connected
If the onsite display is connected, the three operating keys are used to navigate through the
operating menu, ä 29, Section 6.2.3 "Function of the operating elements – onsite display
connected".
6.4.1 Menu structure
The menu is split into four levels. The three upper levels are used to navigate while you use the
lowest level to enter numerical values, and select and save options.
The structure of the MEASURING MENU depends on the measuring mode selected, e.g. if
"Pressure" is selected as the measuring mode, only the functions needed for this measuring mode
are displayed.
–
–
RS_XXXXXXXXXXX (RB2)
EH_DeltabarS-XXXXXXXXXXXXXXXX
➀➁
TRD1_(PCD)XXXXXXXXXXX
SERVICE_(SERVICE)XXXXXXXXXXX
DIAGNOSTIC_(DIAGNOSTIC)XXXXXXXXXXX
DISPLAY_ (DISP)XXXXXXXXXXX
AI1_ (AI)XXXXXXXXXXX
AI2_ (AI)XXXXXXXXXXX
DO_(DO)XXXXXXXXXXX
PID_(PID)XXXXXXXXXXX
ARTH_ (ARB)XXXXXXXXXXX
CHAR_ (SCB)XXXXXXXXXXX
ISEL_ (ISB)XXXXXXXXXXX
INTG_ (ITB)XXXXXXXXXXX
AALM_ (AALB)XXXXXXXXXXX
DI_ (DI)XXXXXXXXXXX
DP_FLOW_(DPFLOW)XXXXXXXXXXX
AI3_ (AI)XXXXXXXXXXX
To Next Page
Loading...
