Commissioning
31
!
Note!
• Any settings that are displayed in gray cannot be selected/cannot be changed (only notes, or
option not available/not activated).
• With the factory setting "0000" (delivery status), configuration is possible at any time. It can be
protected against unauthorized manipulation by entering a 4-digit release code. This has to be
entered when the settings are later changed, if the unit settings are to be changed by keyboard.
Tip: Make a note of your release code. Store it somewhere where unauthorized persons do not
have access to it.
• The altered settings only take effect once you return to normal operation by pressing
Z
several
times and confirming with
F
. Until this time, the unit still works with the previous data.
6.4.1 Set up - Basic settings
Settings that are not channel specific, this means date, time etc.
Procedure for basic settings:
Start
Assign unit identifier
Select the operating language from the list
Select decimal separator (comma or point)
Select temperature unit (°C, °F, K)
Select the save cycle for saving measured values
Select alarm cycle (= measured value save cycle in event of alarm limit violation)
Set the release code. Factory setting: "0000", i.e. unit setting is possible any time without code.
Make date/time settings (e.g. select region for summer time changeover).
Make settings for external memory (CompactFlash)
Set rear illumination. The "screen saver" increases the operating life of the rear illumination.
End
To Next Page
Loading...
Need help?
General