Endress+Hauser Ecograph T RSG30 - The Setup Window and Parameter Navigation

Commissioning
30
6.4 The set up window (at main menu)
Fig. 19: The main menu
Fig. 20: The set up window
The individual parameters are summarized in the set up menu in the following sections:
Input principle:
1. Begin changing parameters each time with
F
.
2. Use
V
or
W
to scroll through the values, symbols and picklists.
3. If the parameter is set correctly, press
F
.
Basic settings
see Section 6.4.1
Settings that are not channel specific, this means date, time etc.
Signal settings
see Section 6.4.2
Settings of the connected analog inputs (incl. set point settings), relays and the digital
input.
Signal analysis
see Section 6.4.3
Set up, in order to obtain signal analysis for presettable time ranges/cycles as well as a
manual reset of the signal analysis. Function only visible if a digital input has been
activated as a counter!
Communication
see Section 6.4.4
Set up only required if you are using the USB, RS232, RS485 or Ethernet interface of the
unit (PC operation, serial data read-out, modem operation, etc.).
Service
see Section 6.4.5
Settings such as calibration etc.
"
Caution!
Changes must only be made by skilled personnel. The unit will operate incorrectly if
incorrect settings are made!