DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
iTEMP TMT71/72 Maintenance
Date Firmware version Changes Documentation
11/2018 01.01.zz Original firmware BA01854T/09/en/01.18
10 Maintenance
In general, no specific maintenance is required for this device.
11 Repair
11.1 General information
Repairs that are not described in these Operating Instructions must only be carried out
directly by the manufacturer or by the service department.
Spare parts currently available for the device can be found online at:
http://www.products.endress.com/spareparts_consumables. Always quote the serial
number of the device when ordering spare parts!
Standard - DIN securing set (2 screws and springs, 4 shaft lock-down rings, 1 plug for the
display interface)
US - M4 securing set (2 screws and 1 plug for the display interface) 71044062
Commubox FXA195 HART
®
, For intrinsically safe HART® communication with FieldCare via FXA195-.......
the USB interface.
11.3 Return
The measuring device must be returned if it is need of repair or a factory calibration, or if
the wrong measuring device has been delivered or ordered. Legal specifications require
Endress+Hauser, as an ISO-certified company, to follow certain procedures when handling
products that are in contact with the medium.
To ensure safe, swift and professional device returns, please refer to the procedure and
conditions for returning devices provided on the Endress+Hauser website at
http://www.endress.com/support/return-material
The device contains electronic components and must, therefore, be disposed of as
electronic waste in the event of disposal. Pay particular attention to the local regulations
governing waste disposal in your country.
Various accessories, which can be ordered with the device or subsequently from Endress
+Hauser, are available for the device. Detailed information on the order code in question is
Endress+Hauser V. 1, Rev. 2, 4-10-2018 41
To Next Page
Loading...
