Endress+Hauser iTEMP TMT71 - 4 Installation; Installation Conditions

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
Installation iTEMP TMT71/72
4 Installation
4.1 Installation conditions
4.1.1 Dimensions
The dimensions of the device are provided in the "Technical data" section →  56.
4.1.2 Mounting location
Head transmitter:
– In the terminal head, flat face, as per DIN EN 50446, direct mounting on insert with
cable entry (middle hole 7 mm)
– In the field housing, separated from the process→  41
It is also possible to mount the head transmitter on a DIN rail as per IEC 60715 using
the DIN rail clip →  41accessory.
Information about the conditions (such as the ambient temperature, degree of protection,
climate class etc.) that must be present at the installation point so that the device can be
mounted correctly is provided in the "Technical data" section→  55.
When using in hazardous areas, the limit values of the certificates and approvals must be
observed (see Ex Safety Instructions).
4.2 Installation
A Phillips head screwdriver is required to mount the head transmitter.
NOTICE
Do not overtighten the mounting screws as this could damage the head transmitter.
‣
Maximum torque = 1 Nm (¾ pound-feet).
10 V. 1, Rev. 2, 4-10-2018 Endress+Hauser