Endress+Hauser iTEMP TMT71 - Status Signal

DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT
Operating menu and parameter description iTEMP TMT71/72
Navigation Diagnostics → Diagnostic settings → Diagnostic behavior
Description Each diagnostic event is assigned a certain diagnostic behavior. The user can change this
assignment for certain diagnostic events. →  39
Selection • Alarm
• Warning
• Disabled
Factory setting See the list of diagnostic events →  39
Status signal
Navigation Diagnostics → Diagnostic settings → Status signal
Description Each diagnostic event is assigned a certain status signal at the factory
1)
. The user can
change this assignment for certain diagnostic events. →  39
1) Digital information available via HART® communication
Selection • Failure (F)
• Function check (C)
• Out of specification (S)
• Maintenance required (M)
• No effect (N)
Factory setting See the list of diagnostic events →  39
14.1.6 "Min/max values" submenu
Sensor min value
Navigation Diagnostics → Min/max values → Sensor min value
Description Displays the minimum temperature measured in the past at the sensor input (minimum
indicator).
Sensor max. value
Navigation Diagnostics → Min/max values → Sensor max value
Description Displays the maximum temperature measured in the past at the sensor input (maximum
indicator).
70 V. 1, Rev. 2, 4-10-2018 Endress+Hauser