System integration Liquiline CM442/CM444/CM448
42 Endress+Hauser
7 System integration
7.1 Web server
7.1.1 Connection
‣ Connect the PC communication cable to the RJ45 port of module 485.
a0016228
Fig. 73: Ethernet connection
7.1.2 Creating the data connection
1. Start your PC.
2. First, set a manual IP address in the network connection settings of the operating system.
This address must be in the same subnetwork as the IP address of the device.
Example:
• IP address Liquiline: 192.168.1.212 (Diagnostics/System
information/Ethernet/IP-Address)
• IP address for the PC: 192.168.1.213
3. Start the Internet browser.
If you use a proxy server to connect to the Internet:
4. Disable the proxy (browser settings under "Connections/LAN settings").
5. Enter the IP address of your device in the address line.
The system takes a few moments to establish the connection and then the CM44 web
server starts.
To Next Page
Loading...
