Commissioning Liquiline CM442/CM444/CM448
54 Endress+Hauser
9.3 Basic setup
Making basic settings
1. Go to the "Setup/Basic setup" menu.
Make the following settings:
2. Device tag: Give your device any name of your choice (max. 32 characters).
3. Set date: Correct the set date if necessary.
4. Set time: Correct the set time if necessary.
For quick commissioning, you can ignore the additional settings for outputs , relays etc. You can
make these settings later in the specific menus.
5. Return to the measuring mode, by pressing and holding the soft key for "ESC" for at least one
second.
Your controller now works with your general settings. The sensors connected use the
factory settings of the sensor type in question and the individual calibration settings that
were last saved.
If you want to configure your most important input and output parameters already in the "Basic
setup", proceed as follows:
‣ Configure the current outputs, relays, limit contactors, controllers, device diagnostics and
cleaning cycles with the submenus which follow the time setting.
Measured value Options
• Depends on the source of
data or output
Factory setting
None
You can display different measured values depending on
the source of data or output.
Label Customized text, 20
characters
User-defined name for the parameter to be displayed
Set label to "%0V"
1)
Action If you perform this action you accept the parameter
name that is automatically suggested.
Your own parameter name ("Label") is lost!
1) "%0V" here stands for text that depends on the context. This text is generated automatically by the software and
inserted in place of %0V. In the simplest situations, the generated text could be the name of the measuring
channel, for example.
Path: Menu/Display/Operation
Function Options Info
To Next Page
Loading...
