Endress+Hauser Liquiline CM444 - Page 61

Liquiline CM442/CM444/CM448 Operation
Endress+Hauser 61
Overflow warnings
Event logbook="Fill up buffer"
Calibration logbook Options
•Off
•On
Factory setting
Off
Decide whether you want to receive a diagnostic
message from the controller in the event of fill-up buffer
overrun of the logbook in question.
Diagnostic logbook
Configuration logbook
Source of data Read only The assigned measuring channel is displayed
Measuring parameter Read only Plain-text information on the parameter that is being
recorded
Main value Read only Information on the main value and the unit.
Unit Read only
Data logbooks
New You can create a maximum of 8 data logbooks.
Logbook name Customized text, 20
characters
Source of data Options
•Sensor inputs
• Controller
• Current inputs
• Fieldbus signals
•Mathematical functions
Factory setting
None
Select a data source for the logbook entries. You can
choose from connected sensors, available controllers,
current inputs, fieldbus signals and mathematical
functions.
Measured value Options
• depend onSource of data
Factory setting
None
You can record different measured values depending on
the data source.
Scan time 00:00:01 to 01:00:00
Factory setting
00:01:00
Minimum interval between two entries
Format: HH:MM:SS
Path: Menu/Setup/General settings/Logbooks
Function Options Info