Technical data Liquistation CSF33
176 Endress+Hauser
Medium properties Vacuum pump
Capacitance level measurement used for:
• Sample media has to be free of abrasive substances.
• Media that tend to create a lot of foam or contain fats and grease
• Media with a conductivity < 30 µS/cm
Peristaltic pump
Sample media has to be free of abrasive substances.
Pay attention to the material compatibility of the wetted parts.
Process connection • Vacuum pump:
Suction line ID 10 mm (3/8"), 13 mm (1/2"), 16 mm (5/8") or 19 mm (3/4")
• Peristaltic pump:
Intake hose ID 10 mm (3/8")
15.9 Mechanical construction
Dimensions See the "Installation" section → 15
Weight
Sampler version Weight
Plastic version with refrigeration 101 kg (223 lbs)
Stainless steel version with refrigeration 118 kg (260 lbs)
Materials Plastic polystyrene VO can change color when exposed to direct sunlight. For outdoor
use without a weather protection cover, the use of Plastic ASA+PC V0 is
recommended. The functionality is not affected by the discoloration.
Non-wetted parts
Cabinet housing Plastic polystyrene V0
For standard applications in wastewater treatment plants and
environmental monitoring
Stainless steel V2A (1.4301)
For standard applications in wastewater treatment plants and
environmental monitoring
Sample compartment inner lining Plastic PP
Insulation Plastic EPS "Neopor®"
Wetted parts Vacuum pump Peristaltic pump
Dosing tube Plastic PP -
Dosing chamber cover Plastic PP -
Conductivity sensors Stainless steel V4A
(1.4404)
-
Conductivity sensors Stainless steel V4A
(1.4404)
-
Dosing chamber PMMA, glass
(depending on version)
-
Dosing system outflow hose Silicone -
Pump tubing - Silicone
Process seal - -
To Next Page
Loading...
