Endress+Hauser Liquistation CSF33 - Page 38

Commissioning Liquistation CSF33
38 Endress+Hauser
Menu/Operation/User definable screens
Function Options Info
Line 1 ... 8 User interface
Label
Specify the content of Label in the submenu of
each line.
Source of data Selection
• None
• See list in "Info" column
Factory setting
None
‣
Select a source of data.
You can choose from the following:
• Sensor inputs
• Binary inputs
• Current inputs
• Temperature
• Memosens sensor input (optional)
• Fieldbus signals
• Mathematical functions
• Binary inputs and outputs
• Current outputs
• Relay
• Measuring range switching
Measured value
Source of data is an
input
Selection
Depends on the input
Factory setting
None
You can display different main, secondary and
raw measured values depending on the type of
input.
No options can be selected for outputs here.
Label Customized text, 20
characters
User-defined name for the parameter to be
displayed
Set label to "%0V"
1)
Action If you perform this action you accept the
parameter name that is automatically suggested.
Your own parameter name (Label) is lost!
1) "%0V" here stands for text that depends on the context. This text is generated automatically by the
software and inserted in place of %0V. In the simplest situations, the generated text could be the name of
the measuring channel, for example.
9.3.4 Basic setup
Making basic settings
1. Switch to the Setup/Basic setup menu.
 Make the following settings.
2. Device tag: Give your device any name of your choice (max. 32 characters).
3. Set date: Correct the set date if necessary.
4. Set time: Correct the set time if necessary.
5. Number of bottles: Correct the set number of bottles if necessary.
6. Bottle volume: Correct the set bottle volume if necessary.
 For quick commissioning, you can ignore the additional settings for outputs etc.
You can make these settings later in the specific menus.
7. To return to the display overview: press the soft key for ESC for at least one second.
 Your sampler now works with your basic settings. The sensors connected use the
factory settings of the sensor type in question and the individual calibration
settings that were last saved.
If you wish to configure your most important input and output parameters in the Basic
setup :
‣
Configure the current inputs, relays, limit switches, cleaning cycles and device
diagnostics with the following submenus.