Wiring Proline Fieldcheck
10 Endress+Hauser
3.1.3 Supervisor mode
If Fieldcheck is operated with the external power unit or a current or frequency measuring cable,
and is not connected to a transmitter, the following message appears on the display after a brief
period:
• In this mode, all the result data saved can be called up and also deleted.
• The version data (hardware/software version, serial number, date of last calibration) can also be
called up.
• If the current or frequency measuring cable is used for supervisor mode, the charging status of the
battery can be read from the USER INTERFACE Block. This status cannot, however, be read
when an external power supply is used.
SUPERVISOR MODE
IS ACTIVATED
CONTINUE WITH ENTER
To Next Page
Loading...
Need help?
General
