Endress+Hauser Proline Fieldcheck - Operation; Display and Operating Elements

Operation Proline Fieldcheck
32 Endress+Hauser
4Operation
4.1 Display and operating elements
The local display enables you to read all important variables of the simulation and configure the
device using the function matrix.
a0001725
Fig. 24: Display and operating elements
1 Liquid crystal display
The backlit, liquid crystal display shows measured values, dialog texts, fault messages and notice messages. HOME
position (operating mode) is the term given to the display during normal operation.
2 Optical sensors for "Touch Control"
3
O/ S keys
– Enter numerical values, select parameters
– Select different blocks, groups and function groups within the function matrix
Press the +/– keys simultaneously (
X
) to trigger the following functions:
– Exit the function matrix step by step  HOME position
– Press the +/- keys longer than 3 seconds  Direct return to the HOME position
– Cancel data entry
4
F key (Enter key)
–HOME position  Enter the function matrix
– Save numerical values entered or altered settings
Display
The display area consists of five lines; this is where measured values, and/or status variables, are
displayed (sequence information of a verification).
a0001706
Fig. 25: Typical display for simulation operating mode with outgoing simulation values and incoming measured values
Esc
E
+
-
1
2
34
MP1 73 sec
+7.012 dm3/m
+7.000 dm3/m
Verif. Transmitter
Flow
I = 17.12 mA F = 783 Hz
+7.012 dm3/m
+7.000 dm3/m
Simulation