Endress+Hauser Proline Fieldcheck - Block SUPERVISION

Device functions - general section Proline Fieldcheck
46 Endress+Hauser
9.4 Block SUPERVISION
9.4.1 Group RESULTS
Block Group Function group Function
SUPERVISION

RESULTS
ä 46

STORAGE
LOCATION
ä 46
RESULT VER.
TRANS. MID
ä 46
RESULT VER.
SENSOR MID
ä 47
RESULT VER.
TRANS. COR.
ä 47
RESULT VER.
SENSOR COR.
ä 47

RESULT VER.
VOR.
ä 47
RESULT VER.
ULTRAS.
ä 47
RESULT VER.
THERM.
ä 47
DEL. STORAGE
ä 48
STORAGE
LOCATION
ä 48
VERSION INFO
ä 48

FIELDCHECK
ä 48

HW VERSION
ä 48
SW VERSION
ä 48
SERIAL
NUMBER
ä 48
CALIBRATION
DATE
ä 48
SIMUBOX
ä 48

TYPE
ä 48
HW VERSION
ä 48
SW VERSION
ä 48
SERIAL
NUMBER
ä 48
CALIBRATION
DATE
ä 48
MANUFACTU
RING/TEST
DATE
ä 48
Function description
SUPERVISION  RESULTS
STORAGE LOCATION Use this function to select the storage location of a verification.
!
Note!
Information about the measuring point and the verification saved appears on the display.
Options:
1 to 20
Display:
1st line: storage location no.
2nd line: measuring device type and size
3rd line: serial number and tag name
4th line: date of verification
5th line: result
RESULT
VERIFICATION
TRANSMITTER MID
Use this function to call up the results of the verification. The result (PASSED, FAILED) is
displayed on the information line.
If the results of a linearity check are called up, the list of measured values also appears
when confirming the selection.
Options:
ZERO POINT
AMPLIFIER (with list of measured values)
CURRENT OUTPUT (with list of measured values)
FREQ. OUTPUT (with list of measured values)
PULSE MEASUREMENT
SENSOR