Identification Proline Fieldcheck
8 Endress+Hauser
2.2 Scope of delivery
The equipment supplied with Fieldcheck comprises the following components:
• The Fieldcheck flow simulator with battery pack
• A connecting cable for the service interface
• A connecting cable for the Simubox
• Two connecting cables for the current and frequency output
• An RS 232 connecting cable for connecting Fieldcheck to a computer (
9-pin COM interface)
• A power adapter
• A softcase
• Operating Instructions
The Simuboxes for the respective flow measuring systems, the sensor test boxes and the system-
specific sensor adapters are available via separate order numbers.
2.3 CE mark, Declaration of Conformity
The devices are designed to meet state-of-the-art safety requirements, comply with good
engineering practices, have been tested, and left the factory in a condition in which they are safe to
operate.
The devices comply with the applicable standards and regulations in accordance with EN 61010-1
"Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures" as well as with the EMC requirements of IEC/EN 61326.
The measuring system described in these Operating Instructions meets the statutory requirements
and complies with the EC Directives which are listed in the Declaration of Conformity.
Endress+Hauser confirms successful testing of the device and compliance with the EC Directives
by affixing the CE mark.
2.4 Registered trademarks
HART
®
Registered trademark of the HART Communication Foundation, Austin, USA
PROFIBUS
®
Registered trademark of the PROFIBUS User Organization, Karlsruhe, Germany
FOUNDATION™ Fieldbus
Registered trademark of the Fieldbus FOUNDATION, Austin, USA
Fieldcheck
®
Registered trademark of Endress+Hauser Flowtec AG, Reinach, Switzerland
FieldCare
®
Registered trademark of Endress+Hauser Process Solutions AG, Reinach, Switzerland
To Next Page
Loading...
Need help?
General
